![]() You have now successfully set up a static IP address on your computer. Note: You can set the DNS server(s) to Google’s addresses which are 8.8.8.8 and 8.8.4.4. Once done, click OK on all open windows to close them. ![]() In the next Properties window, select the “Use the following IP address” radio button and then fill in the fields below from the information obtained from the Command Prompt earlier which includes the IP address, subnet mask, default gateway, and DNS server(s). On the Properties window, click Internet Protocol Versions 4 (TCP/IPv4) and then click Properties. From there, right-click the network adapter connected to the router and click Properties from the context menu. To configure a static IP address on a Windows 10 machine, type in ncpa.cpl in Run to open the Network Connections window. We will be assigning the same IP address manually to make it static. In the image above, the IP of our target PC is 192.168.100.245. In our case, we are using Wi-Fi to connect to the router: You need to look for the “IPv4 address” under the network adapter that is connected to the router, it may be wired or wireless. This command will display all the IP configurations of all network ports on the PC, including virtual ones. To identify the current allotted IP address, open Command Prompt and type in ipconfig /all. Before we do that, let us see what the current IP address of the machine is so that we allocate the same static IP address to avoid an IP address conflict with any of the other devices on the network. Therefore, we must set a static IP address for this right now. For that, we need the IP address of this machine to be static, i.e. However, in a further step down the article, we will require to forward a port onto the IP address of this target PC. This protocol automatically allots vacant IP addresses to all connected devices to avoid any IP conflict. Set static IP addressīy default, most routers are set to Dynamic Host Configuration Protocol (DHCP). Let us now proceed with the other configuration steps. Remote Desktop connection is now successfully enabled on your PC. Open the Remote Desktop setting in the Settings app (Run -> ms-settings:remotedesktop) and toggle the slider under Enable Remote Desktop. The same can be achieved using the Settings application in Windows 10. Enable remote desktop connection through Settings app In the System Properties window, select the radio button next to “Allow remote connections to this computer” and then make sure the checkbox under it is checked. Open the Control Panel, click System and Security, and then click Allow remote access under System. Enable remote desktop connection through Control Panel There are 2 ways to enable remote desktop connection in Windows 10. It needs to be enabled and allowed through the firewall for a successful Remote Desktop Protocol (RDP) connection. The Windows 10 firewall blocks any remote connections by default. Enable/allow remote connection on Windows 10 PC Here are 4 ways you can prevent it from happening. Therefore, it needs to be configured such it does not enter sleep mode. Meaning, if a computer is in sleep mode and you are trying to access it remotely, it will be an unsuccessful attempt. When a computer enters sleep mode, it is no longer responsive to network calls. Install & configure Microsoft Remote DesktopĬontinue reading the step-by-step guide to perform all of these tasks.Configure DDNS (in case of dynamic public IP address).The process we are about to discuss needs to be performed in the same order. ![]() Install & Configure Microsoft Remote Desktop on source PC.Enable remote desktop connection through Settings app.Enable remote desktop connection through Control Panel.Enable/allow remote connection on Windows 10 PC.Prevent your PC from entering sleep mode.
0 Comments
Leave a Reply. |